DALI Gateway

This DALI gateway is developed to allow for communication between DALI devices and the KNX/EIB. It requires KNX bus input DC30V. 3 DALI bus output channels can be connected to the DALI gateway with a maximum of 64 per channel. So overall, up to 192 devices with DALI interface (e.g. LED lamps with DALI drivers) can be connected to the gateway. Each output can be controlled separately with regards to the functions of switching, dimming, setting brightness values, and lamp/ballast error signals.

Logic Input Module

Equipped with KNX interface, this logic input module is designed to easily adapt to a variety of conventional panels, buttons, etc., and enable their connection to KNX network. It is capable of converting all switch signals received into KNX signals, to meet the specific requirements of all sorts of alarms, sensors, etc. It supports 12 input channels for connection to sensors, conventional push-buttons, contacts, etc., 12 output channels to drive low-voltage LED for synoptic panels or switches, and additional 4 input channels to connect either 4 temperature sensors (with On/Off threshold) or 2 thermostats for HVAC control.

KNX Switch Actuator

The switch module can drive for 8 channels loads and control the switch-on/off independently of each other. Connected to a KNX bus system, this module is enabled to open/close fresh air, floor heating and air conditioning systems and lights of all brands and models.

DALI Bus Power

This DALI bus power is fully compliant with the IEC62386 DALI standard and can be used with any DALI-certified product or controller. 18-48V wide range input ensures a safe operation for installing. The power output is current limited to 250mA/voltage 16V, sufficient to power a complete DALI zone with up to 64 individual DALI devices.

DALI Led Driver

DALI-30W is a high performance LED driver that features light scene control, output current settings from 0 to 980mA, and LED status check. It implemented smooth dimming support from 0% to 100%, with the ability to turn LEDs completely off. This DALI driver is engineered to achieve above 90% (maximum 94%) efficiency and to offer extended driver life if use with high quality components. It supports connection to all major LEDs with a voltage ranging from DC5V to 45V, and timely check of the light status in order to achieve accurate and fast repair.

KNX Power

The KNX power is a unit that provides voltage for EIB/KNX system, output1280mA. It is a standard power supply unit for KNX bus, coupled with the bus components through an integrated choke inside the power, and connected to KNX bus line through a bus connector. KNX-1280A has an additional auxiliary 30V DC output which may be used to power an additional bus line if connected in parallel to a separate choke that has meet all parameter requirements.

Led-Driver

Integrated with the dimming circuit and current adjusting circuit developed by enno, this 1-10V LED driver is designed to allow for the use in wide input voltage ranging from DC 15V to 48V and adjustment of output current ranging from 0.2 to 0.98A. It can be set up to connect various types of LED lights in market and illuminate the magical world of lights through precise control of the dimming intervals. The shift from any brightness level to another is smooth without flicker and a close imitation of the nature light changes.

KNX Gateway

Enno KNX/RS485 Gateway is designed to serve as the interface between KNX and RS 485 to allow for scaled control of up to 64 air conditioners and 8 lighting circuits. It could be used to facilitate the control of buildings or houses where more than 3 air-conditioners or 8 circuits of lights are required. The control of lights includes switch on/off and dimming; the control of central AC units includes switch on/off, mode selection, temperature and fan speed adjusting, and the AC units could be based on one of the three protocols -- BacNet, Modbus, or a customized RS485.